The JK-84 “Oasis” wireless alarm kit
1 / 2
MKE59904
The JK-84 “Oasis” wireless alarm kit
Installation of the JK-84 kit shall only be undertaken by technicians
holding a certificate issued by an authorized distributor. This simplified
installation manual only describes the basics, for more details see the
manuals of particular devices.
1.
Factory-default pre-enrolled devices
Address
Device
Note
05
JA-83M door detector Delayed reaction
06
JA-83P PIR detector
Delayed reaction
48
RC-86 keyfob
Buttons
and
pre-enrolled
49
JA-81F keypad unit
Connect a magnetic door sensor
to its IN input.
50
JA-80L indoor siren
JA-82KR
Pre-enrolled to the JA-80L
2.
Control panel and keypad installation
1. Attach the Control Panel (CP) to the desired location.
2. Connect back-up battery to the CP (attach it securely with
adhesive tape).
3. Connect the mains to the CP – its green LED will start flashing
4. Connect up the batteries in the JA-81F keypad – service mode
should be displayed (if not, disconnect the keypad batteries, check
that the control panel is powered up and reconnect the keypad
batteries).
The internal keypad menu can be entered in Service mode by
holding the
?
key. Using the arrows on keys 1 and 7 you can scroll
thought this menu:
Display
Key
Description
Tamper ON
Disable / Enable the tamper sensor
(only for service purposes)
Door chime ON
Disable / Enable sound when IN triggered
Beeper ON
Disable / Enable system sounds
Brightness
Sets the display brightness 0 - 9
Contrast
Sets the display contrast 0 - 9
Edit text
Entry to keypads text editing
English
Sets English (reload default texts)
To exit the menu, press # (exiting also occurs after 10 seconds’ inactivity)
o
If you exit Service mode accidentally, it can be re-entered by
keying in
∗∗∗∗
0 8080.
o
Close the keypad’s flip cover to save the battery while in the
service mode.
Before attaching the JA-81F keypad, test that it functions correctly at
the desired location. We recommended wiring up a magnetic door
sensor (provided with the kit) to the keypad’s IN input. This will ensure
that the keypad is “woken up” whenever the door is opened (to indicate
system status, to make entrance delay beeps and to have the access
card reader ready for reading cards).
3.
Installing the detectors and the siren
1. Install the JA-83M magnetic detector, select its reaction via the
internal DIP switch (INS/DEL), connect its battery up and close the
cover.
2. Install the JA-83P PIR motion detector about 2 to 2.5 meters above
the floor, select its reaction via the relevant internal DIP switch
(INS/DEL), connect its battery and close the cover.
3. Plug the JA-80L siren into a mains power socket.
B
A
B
+
B
A
B
reed contact
tamper
INSTANT
DELAY
serial number
battery CR123A
1
2
3
4
5
6
7
8
9
1
2
3
Main board
Transformer
Back-up battery
Mains terminal
Digital bus connector
Tamper switch
LED
Antenna connection
0
1
0
2
C
O
M
0
3
0
4
E
W
IW
P
G
X
P
G
Y
G
N
D
A
B
+
U
RESET
1 2 3 4
ON
OFF
Radio module
Antenna
1
2
V
2
,4
A
h
