JABLOTRON
ALARMS
a.s.
Pod
Skalkou
4567/33
46601
Jablonec
n.
Nisou
Czech
Republic
www
.jablotron.com
||
|
JA-14K(R) Security System Control Panel
57 / 72
MNX22101
DNS server
– setting for manual DNS server IP assignment that is only available if automatic assignment from
the DHCP server is not enabled. The default setting is 192.168.1.1
MAC address
– unique address of every LAN device (identification of data source)
LAN device for identification of the source of information
Test DNS
– when the LAN communicator is connected to the Internet, the settings can be tested for
correctness. If a green dot appears after pressing of the button, the connection to the server has been
established, but if a red dot is displayed after a few seconds, the time for establishing the connection has
expired, which indicates an incorrect setting or an error in the LAN communicator connection.
10.10.3 PSTN Settings (JA-190X)
It is used to set the phone communicator JA-190X (if the control panel contains one).
PSTN Module
– possibility to enable or disable communication over a phone line.
Remote control via telephone
– setting the possibility to control the system remotely using the voice menu. If
Users are selected, the menu can only be accessed from the phones of defined users (in the Communication
tab you can even allow users to enter the voice menu without entering their user code – the Voice menu without
code option). If Anybody is selected, the voice menu can be accessed from any phone. However, on accessing
the menu the user is always requested to enter the user’s code.
No code for voice menu and control SMS
– When the user accesses the system, it is not required to enter
the code (authorized by its own telephone number). It is necessary to have caller ID service (CLIP) activated.
Generated DTMF level (for ARC)
– setting the intensity of the transmitted tone dialling signal in DTMF
generated by the control panel. The intensity is adjustable in 10 steps; the optimum default value is 4.
DTMF detection sensitivity (from ARC)
– setting the sensitivity of reception of the signal generated
by the alarm receiving centre. The sensitivity is adjustable in 10 steps; the optimum default value is 4.
Number of incoming call rings
– number of ringing impulses until the call is answered by the communicator.
Answering can be set after 1 to 10 ringing impulses (corresponding from 5 to 50 seconds). The default value
is 3 (15 seconds).
PSTN access prefix
– code for dialling through the internal phone exchange
Detection of dial tone
– if this parameter is off, the communicator will start dialling the set phone number
regardless of the type or presence of dialling tone. If it is on, the communicator will not start working until it
detects the dialling tone (e.g. dialling tone assignment delay in some phone exchanges)
Detection of busy tone
– if the communicator detects the engaged tone, e.g. in a parallel line, it will hang up
and inform the system. You are not recommended to enable this parameter as the communicator
does not detect hanging up.
Phone line check
– The communicator completely disables detection of voltage in the phone line.
It means that it will not report the torn-off phone line error. If it gets torn-off, an error will be indicated after
30 min. from the detection of phone line loss. The communicator indicates the error using a yellow LED.
Simulated telephone line
– If activated, the communicator does not check presence of the phone line
or its tones. Thus, it will not detect a phone line error at a lower voltage than 15 V. The use is designed for radio
modems.
You will find a detailed description of parameter settings in the manual of the JA190X phone communicator
module.
