5
To come out from the SET FUNCTIONS:
Wait the end of the signal and place the GT889 handsets contacts to the receptacle (not
during the Function No. 3 - HANDSETS SELF-CODING). The exit is confirmed by the Led
switching off and by 5 beeps.
In the “FUNCTIONS TABLE” are mentioned the functions which can be selected.
SELF-CODING emergency procedure.
In case of GT889 handset-electronic key loss it is possible to enter the SET FUNCTIONS:
A - With the alarm disarmed disconnect the power supply and wait 1 minute.
B - Short-circuit the RECEPTACLE/LED with a metallic body the RECEPTACLE/LED
contacts.
C - Reconnect the power supply.
D - Turn the ignition key on-off 4 times (make a pause of 2 seconds at each state).
E
-
When the SET FUNCTIONS has been entered, this is confirmed by 5 BEEPS and by
the RED LED constant switching on.
F - Remove the short-circuit between the RECEPTACLE/LED contacts and proceed as
indicated in the self-coding procedure.
SET FUNCTIONS TABLE
FUNCTION STATE
No.
DESCRIPTION
ENABLED
DISABLED
1
SHOCKS/MOVEMENT SENSOR
SENSITIVITY ADJUSTMENT
GREEN
1
1
HIGH
RED
1
1
MEDIUM/HIGH
2
SHOCKS/MOVEMENT SENSOR
SENSITIVITY ADJUSTMENT
GREEN
2
2
MEDIUM/LOW
RED
2
2
LOW
3
REMOTE CONTROL HANDSETS
SELF-CODING
RED
3
3
NOT
AVAILABLE
4
RAPID TEST
RED
4
4
NOT
AVAILABLE
5
ACOUSTIC SIGNAL WHEN
ARMING/DISARMING
GREEN
5
5
RED
5
5
6
POSITIVE OUTPUT WHEN THE
ALARM IS ARMED
GREEN
6
6
RED
6
6
7
EMERGENCY INDICATORS
FLASH
GREEN
7
7
RED
7
7
8
AUTOMATIC
ANTI-HIJACK
GREEN
8
8
RED
8
8
FUNCTION STATE
FUNCTION STATE
N
1
N
N
2
N
N = N = Function No.
N = Led flashes No.
N = Beep No.
1
2
1
2
DEFINITE SETTING OUT
LEGEND:
-
SHOCKS/MOVEMENT SENSOR SENSITIVITY ADJUSTMENT (Function No. 1 No. 2).
With this function it is possible to adjust the shocks/movement sensor sensitivity choosing
between 4 levels: high, medium/high, medium/low and low.
1 - Select the function and ENABLE/DISABLE pressing the “OFF” remote control handset
button.
Note:
on the Led it is visualised only the active adjustment. For example if it is active the
High sensitivity the Led will emit 1 green flash during the function 1 and during the function
2 you will obtain 2 beeps without any Led signal.
