jablotron Azor, User Manual

Page: 14 / 25

MLO51206 - 14 -
Control
The following description applies to Azor’s default settings. However, you can adjust its
behaviour as you wish – see the Settings.
A RFID tag reader is usually used to control Azor at the protected premises . Users whose
telephone has been enrolled to the system can also control Azor via the voice menu.
The access to the menu can be protected with a personal User’s code – see the Settings.
Switching Azor on/off
Azor can be switched on/off by holding the GSM control unit button. Azor reports
its switching on/off (to the ARC and also with an SMS message).
Setting Azor
− Press the SET button on the RFID tag reader (A) and scan the RFID tag (B)
− The red LED indicator in the reader lights up and a 1 minute exit delay is launched
− Detector activation will not trigger an alarm in this time
− Azor will confirm its setting with a longer beep
Tips and specifications

The system can also be set via the telephone voice menu.

A different exit delay can be set (see the Settings).

If you press the RFID tag reader button in a set state, a red LED indicator lights up.

When a detector is activated in the set state, an alarm is triggered. However,
a 30-second entrance delay during which the user can unset the system is launched first (a
different delay can be set or it can be disabled for individual detectors – see Settings).

If there is any unauthorized manipulation of any part of the system in the set state, a tamper
alarm is triggered.

If the user has enabled SMS reporting when the system is set, no report is sent to them if they
set the system themselves by own remote control or RFID tag. An RFID tag marked by a colour
label on it is for the user whose phone number was enrolled as the first one. No setting is
reported when it is cancelled during the exit delay. This reduces unnecessary SMS messages if
you forget something when exiting the place and you have to return for it.