![background image](http://html1.mh-extra.com/html/jabiru/j120/j120_technical-manual_3130523164.webp)
Aircraft Service Manual
Jabiru Aircraft
Pty Ltd
JTM001-1
J120, J160, J170, J200/J400, J230/J430, J250/J450 Variants
REVISION
1
Dated: Nov 2011
Issued By: SW
Page: 164 of 233
13.7.3 THROTTLE INSPECTION, REPAIR & RIGGING
13.7.4
When adjusting any engine control, it is important to check that the control slides smoothly
throughout its full range of travel and that the lever or knob moves through its full range of travel.
This must be verified both at the carburettor and inside the cabin.
Check for chaffing or fraying of the cable.
13.7.5 THROTTLE INSTALLATION
Reverse the removal procedure given above for installation.
Adjust throttle stops (mounted on the throttle pushrods for panel mount throttle and on the seat
front / floor for seat-mounted throttle) to give full throttle and correct idle speed. Details for
procedures can be found in the engine Instruction & Maintenance Manuals.
Adjust friction of shaft clamps to ensure throttle does not move from a set position.
WARNING
Adjustments must be set with care: poorly adjusted throttle stops can result in engine
stoppages, apparent loss of power or increased landing distances due to high idle.
Poorly adjusted friction stops can result in throttle position creeping
– resulting in un-
commanded application of high power.
CASES OF SEVERE DAMAGE TO AIRCRAFT DUE TO THESE EFFECTS HAVE BEEN RECORDED
Figure 135
– Throttle Assy (Seat Mounted)