Aircraft Service Manual
Jabiru Aircraft
Pty Ltd
JTM001-1
J120, J160, J170, J200/J400, J230/J430, J250/J450 Variants
REVISION
1
Dated: Nov 2011
Issued By: SW
Page: 121 of 233
Check UP travel on both ailerons using the Aileron Rigging Template (see Appendix 3).
Use the Aileron Control Stop adjustment on the central control shaft to adjust the total aileron
movement (i.e. UP travel) and use cable adjustment as previously described to proportion UP and
DOWN travel. Note that while it is possible to adjust the Type 3 aileron stops using the eccentrics
using the limit screws shown in Figure 82 is easier.
DO NOT move the Cable Anchors
– these positions have been set using a jig.
WARNING
The control cable must be connected to the same side of the control column bellcrank as the
wing to which the aileron is fitted, otherwise control surface reversal will result.
DO NOT CROSS CABLES
Figure 89
– Aileron Stops – Type 1
