Model 279 J Series
LED Jeep Tail Light Instruction Sheet
Tools Needed
Phillips Screwdriver
Pliers OR Adjustable Wrench
Estimated Time
30 minutes
In the Box
(x2) Model 279 J Series Tail Lights
A.
(x2) Resistor Mounting Brackets
B.
(x4) Tinnerman S-Clips
C.
(x4) #4-40x0.312" Screws
D.
(x4) #4-40 Lock Nuts
Regulatory Compliance
To properly install this light you should have a good understanding of automotive electrical procedures and
systems, and proficiency in the installation of tail lights. If you do not, please seek professional assistance.
INSTRUCTIONS BEGIN ON THE NEXT PAGE
Input Voltage
Operating Voltage
12-24V DC
Single lights come with half of the above parts
10-32V DC
Page 1
B
C
D
A
J.W. Speaker Corporation • Germantown, WI U.S.A. • www.jwspeaker.com • [email protected] • 262.251.6660
6544230b
Rev: 05/19/2016
PRE-INSTALLATION INFORMATION
Pre-Installation Guidelines
1. Read all safety notes and mounting guidelines before installing
the product. Verify that all parts listed under “In the Box” are
present and complete.
2. Inspect the product for damage.
DO NOT
install the product if
there is any damage. Contact the authorized retailer where you
purchased it to initiate a warranty claim if there is damage.
3. Verify that all power supply and/or charging systems comply to
the specified voltage limits for the light.
4. Turn off the vehicle and disconnect the battery.
PRODUCT WARRANTY:
If you have issues with a J.W. Speaker
product, please contact the authorized
retailer where you purchased it.
