Model 272
LED Signal Light Instruction Sheet
Note: If product does not meet
any regs to use the approval
logos, REMOVE section
altogether, and move
Installation Guidelines up.
J.W. Speaker Corporation • Germantown, WI U.S.A. • www.jwspeaker.com • [email protected] • 262.251.6660
6542930b
Rev: 03/07/2016
Installation Guidelines
BEFORE INSTALLATION:
1. Read all safety notes and mounting guidelines before installing
the product. Verify that all parts listed under “In the Box” are
present and complete.
2. Inspect the product for damage.
DO NOT
install the product if
there is any damage. Contact the distributor where you purchased
it to initiate a warranty claim if there is damage.
3. Verify that all power supply and/or charging systems comply to
the specified voltage limits for the light.
Estimated Time
30 minutes
Wire Functions
See Next Page
In the Box
(x1) Model 272 Signal Light
For a complete list of product
specifications, scan the QR code to
the right, or visit www.jwspeaker.com
and search “Model 272.”
Regulatory Compliance
Product Specifications
Input Voltage
Operating Voltage
12-24V DC
9-32V DC
PRODUCT WARRANTY:
If you have issues with a J.W. Speaker product,
please contact the authorized retailer where
you purchased it.
CONTINUED ON THE NEXT PAGE
Page 1
INSTALLATION:
1. Turn off the equipment and disconnect the power supply.
2. Ensure that the mounting location is a FLAT, SOLID surface of the
same (or larger) size as the bracket or light. This will prevent warping
or distortion that can cause cracking or damage to the light and/or
bracket.
3. Check condition of all wires, connectors, mating connectors, or
gaskets. All connections should be adequately protected against
moisture. Shrink tubing is recommended.
5. Carefully connect the wires or connector using the “Wire
Functions” and “Voltage” information above. With connectors, push
firmly to ensure that it is properly mated with the lamp, creating a
seal to protect against water ingress.
4. Lay and secure the wiring so that no pulling or abrasion can occur.
Proper installation requires there to be a little slack near the lamp to
avoid pulling on the connector (which can create a path for water
ingress). Wires should be adequately secured to avoid damage.
6. Secure it to the mounting surface then aim the light (if applicable).
7. Periodically check the light to make sure that it is working properly
and is securely attached.
PRE-INSTALLATION INFORMATION