P
RODUCT INFORMATION
load, the air consumption is 5,5 (195)
m
3
min
(
cf m
).
3.8.4. Quality of the compressed air
NOTICE
There is a danger of icing in the motor if there is
moist air and ambient temperatures at or below
0
◦
C (32
◦
F)!
You can avoid icing by:
I
Connecting an air dehydrator upstream
I
When using a service unit with an oiler, de-
pending on the moisture content of the com-
pressed air, add an anti-icing agent to the lubri-
cating oil or use an air lubricator (type no. 11900)
with an anti-icing addictive for the corresponding
temperatures.
Your product
PROFI 16 TI
must be operated with a
sufficiently clean and dry working air. The working
air must meet the following quality requirements:
•
Particle size less than 40
µm
(1,57mils)
•
Particle density smaller than 10
mg
m
3
(entspricht
Class 7 nach ISO 8573-1 : 2001)
To provide a sufficient compressed air quality, we
recommend operation with a filter regulator.
The pressure condensation point must be at least
10K below the lowest expected ambient tempera-
ture.
Do not operate your product with other gases!
3.9. Operating materials
CAUTION
Danger of skin irritation
Oils and greases may cause skin irritation.
I
Wear protective gloves
NOTICE
Do not mix synthetic oils or greases with mineral
oils or greases, as the properties may deterio-
rate. Also never mix different types of lubricating
grease within the synthetic or mineral lubricant
groups. When operating with oilers, synthetic
lubricants may never be used. Alcohols are not
permitted as de-icing agents.
The following operating materials and lubricants
are intended for normal environmental influences.
In the event of environmental influences that pro-
mote wear, please contact J.D. Neuhaus to obtain
appropriate information.
Doc.-No.: VA049318-20-OM-EN-0319-64-6
Page
21
of 64
