16
/16
System Operation Manual - E3 Dash
10/29/14
Solution
The battery or charger may be damaged. Stop using the battery and
charger immediately, and bring them to your dealer for inspection.
The output of the charger is short-circuited.
Solution
Stop using the battery and charger immediately. Check for obvious
external shorts on the charging plug and battery charging port. If no
obvious short exists, the battery or charger may be damaged. Bring
them to your dealer for inspection.
Other issues causing a flashing red LED:
The temperature of the battery is too high to charge.
Solution
Put the battery and charger in a cool place, then try charging again
after a few minutes.
ISSUE:
Charger LED indicator
stays green when plugged into the battery.
There is no connection between the charger and the battery.
Solution
Check for damage: battery charging port, charging plug, charging
cord, and power cord
.
There may be an internal problem with the battery or charger. Bring
them to your dealer for inspection.
The battery’s voltage is too low to be charged.
Solution
Check the battery’s charge level as described in this document. If the
battery will not turn on, the battery may be damaged and should be
inspected by your dealer.
Misc issues
Lost key
If you have lost your keys, note your bike’s serial number (
located
underneath the frame’s bottom bracket
) then call EBCC customer
service at (800) 377-4532.
No power from battery
The battery has a user-replaceable fuse located at its base. The
fuse is not installed at the factory; you must install it before using
the bike for the first time.
If the fuse is present but the bike still does not power up, inspect
the fuse; if it is blown out, it can be replaced with a standard 30-amp
automotive fuse.
Good Blown
M19+下管電池+BB03
