Error messages and indications
You should then check whether your CAN network generally works with inverted
polarity. If this is the case, you should change your CAN network to not inverted
polarity. If this is not possible, you can still carry out the dependent tests with the
CANcheck with the aid of a special adapter cable, where CAN_H and CAN_L are
inverted.
6.5 Error message after cancelling a test
Baudrate detection
Test rejected
If the tests dependent on the baudrate detection (see section 6.4) are canceled
with the ESC key during baudrate detection, the above error message appears. In
this case the baudrate detection has failed and you do not receive a test result.
In this case, please check:
•
whether the CAN network is operational
•
whether the CAN network works with a supported baudrate (see section
10.1)
6.6 Indication of a non-periodic identifier
Signal levels per
▼
S : Standard ID
E : Extended ID
Vd: CAN_H -> CAN_L
Va: CAN_H -> CAN_GND
17 Identifiers found
15 Identifiers OK
Signal levels per
▼
▲
15 Identifiers OK
2 Identifiers PER?
0 Identifiers ERROR
S 386 : 2.0Vd[OK]
: 3.5Va[OK]
S 388 : 1.9Vd[OK]
Copyright IXXAT Automation GmbH
CANcheck Manual, Version 1.2
55
