Error messages and indications
6 Error messages and indications
6.1 Error message after switching on
Self test
failed
Error 1
FAIL
-Settings
The CANcheck executes a self-test, when it is switched on. If the self-test fails, the
message "Self test failed Error <no.>" appears for approx. 2 seconds. Then FAIL
appears in the header. The only supported menu item is "Settings".
Error number 1 means that the battery voltage is too low. With the menu item
"Settings" you can check the battery voltage. The batteries must be replaced if the
battery voltage is less than 4.0 V.
6.2 Error messages when CAN nodes are not switched
off
Wiring test
Voltage detected
on CAN bus
Test rejected
Copyright IXXAT Automation GmbH
CANcheck Manual, Version 1.2
52
