IXXAT CANblue II, User Manual

Page: 20 / 64

Configuration as Generic PC Interface or as Bridge 18 (62)
7.1.3 Examples
CANblue II command and CANblue II reply:
>c can_init 1000
I OK: CAN_INIT
Local command and local output:
>#print CANblue Generic
# CANblue Generic
7.2 Configuring an Interface
The installed virtual Config COM port is used to configure the CANblue II to exchange data with
a CAN network connected to the CANblue II.
► Make sure, that the software package and the virtual COM port are installed.
► Start and configure the desired configuration tool (see Configuration Tools, p. 16 ).
► Reset the device to factory settings with command
D SETTINGS_DEFAULT
.
➨ Existing filters and settings are deleted.
➨ Factory settings are set (information about settings see Reset to Factory Settings, p.
23 ).
► Initialize the CAN controller with the desired baud rate with command
C CAN_INIT <baudrate>
.
► Set the filter (see Configuring the Filter, p. 22 ).
► Specify further settings (see Settings in Generic Mode, p. 22 ).
► Check the configuration with command
C CONFIG SHOW
.
► Save the configuration with command
C CONFIG SAVE
.
► Start the CAN controller with command
C CAN_START
.
➨ If the CAN controller receives a message from the CAN network that matches one of
the filters, the message is transmitted on the Bluetooth connection in ASCII format.
CANblue II
CAN connector
Bluetooth
connection
(SPP-Server)
CAN bus 1
PC
Bluetooth
Config
Slave
Master
Bluetooth connection
CANblue II User Manual 4.01.0126.20000 EN 3.2