Remote Control System TT801 – User Guide
MU-TT801-AN rev.6 September 2009
37
III.4.3 L
OADING A
P
RE
-P
ROGRAMMED
C
ONFIGURATION
The access to this sub-menu is allowed by pressing
2
key in
TX / RX settings
menu and
then by pressing
1
key in the
DATABASE
menu. Then, the DATABASE/LOAD display
opens with the first instrument available in the database.
DATABASE
/ LOAD
IDENT
:
001
TYPE
: RT8xx
TRANSMIT TYPE :
ARM + CMD
CODE ARM :
EFFE
CMD : EFCD
COMMAND :
OTHER CMD
SCROLL = CHOICE
ENTER = VALID
Step 1
Step Action
1.
Select the new device to be loaded with
SCROLL
key.
TT801 displays the main parameters of the instruments selected.
To make correction of the ID, use the
CLEAR
key:
A blank window opens with requirement for an ID number.
You must then type in an existing saved ID number and confirm by pressing the
ENTER
key to display the configuration of the selected instrument. If the selection is not valid,
the message “
ID NOT REGISTRED
” is prompted and you are required to exit (“HOME”
key) or to type in a new ID number.
Then, press
ENTER
key to confirm the selection; the Transmit/Receive display opens
automatically. To proceed further, skip to section III.5.
2.
End of procedure.
Note
If several devices have been registered with the same ID number, the first one saved
with this ID number will be loaded.
Procedure
Summary of Contents for TT801
Page 1: ...TT801 Remote Control System User Guide...
Page 2: ......
