GAPS
-
User Guide
6.3.2
C
ONFIGURING THE
C
ONNECTION
The equipment has been created in section 6.3.1. The connection between the equipment and
DELPH RoadMap is configured both in the dedicated user interface of the device and in
DELPH RoadMap. Please refer to the chapter describing the configuration of the output data
flow in the appropriate device user guide. The configuration of DELPH RoadMap is described
below.
The following ASCII protocols may be received on the same connection when they are
present in the device data output:
●
Acoustic Positioning iXblue Standard (GAPS Standard, DATA Standard, RAMSES
Standard, etc.)
●
INS iXblue Standard (PHINS Standard)
●
GPS NMEA (GPGGA, GPGLL, GPRMC, etc.)
Only ASCII protocols are decoded.
1.
Select the
Connection
tab.
2.
Select one or several
Protocols
to receive from the equipment if relevant.
3.
Select the
Connection
between
Ethernet TCP
,
UDP
and
PC Serial Port
.
4.
If you selected
Ethernet TCP
, enter a
Communication Port
and the
IP address
.
5.
If you selected
Ethernet UDP
, only enter the
Communication Port
.
98
MU-GAPS-AN-005-H - November 2019
Summary of Contents for GAPS
