Hardware User Manual for G8 Q7M i.Mx51 Module
Rev 1.0
Page
25
of
34
iWave Systems Technologies Pvt. Ltd.
5. Hyper Terminal Set up & boot OS from NAND Flash
5.1 Hyper Terminal Set up
1.
Insert one end of the serial cable to PC/Laptop COM port (DB9 Male Connector.)
2.
Connect the other end of the serial cable to serial connector of the Board.
3.
Open the HyperTerminal on the PC/Laptop as mentioned below
4.
Go to Start -> Programs -> Accessories -> Communication -> HyperTerminal on the
host PC/Laptop.
5.
In hyperterminal,Go to Files ->Properties
6.
Select COM1 or COM2 port depending on which port you have connected the serial
cable as shown below.
Figure 6: HyperTerminal settings-1
