Ivoclar digital PrograMill Base, Operating Instructions Manual, Page: 108 / 144

Editing Milling Jobs
108

The milling progress of the job is displayed.

The remaining processing time of the milling job is shown in the status display:
7.5 Starting several milling jobs (Multi mode)
In the main menu [Cases], in the tab [New], all milling jobs transferred from the Ivoclar Digital
system solution to the PrograMill One device, which are ready for processing, are shown (“Tab
[New]”, page 57).
You can transfer as many milling jobs as required to PrograMill One for later processing.
PrograMill One can process a maximum of 5 milling jobs in one milling sequence in the Multi
mode (5 blocks can be placed in the material and tool changer).
This sequence can be defined as required by the user. After successful processing of the 5
defined milling jobs, the next 5 can be prioritized and prepared.

You are in the main menu [Cases].

At least two milling jobs are displayed.
1. Tap on the tab [New].
The transferred jobs will be shown.
2. In order to define the new milling job
sequence, tap on next to every
milling job in the desired order.
Next to the selected milling job,
depending on its position in the milling
sequence, the following is displayed:
, , , or
00:02 00:20
2 3 4 5