DIGISPENSE 3009 CONTROLLER MODULE, STYLE B
Page 3-102
29 October, 2019
IVEK Corp. P03R017E
To start metering press the START button or supply a trigger to the rear panel. The system will dispense the liquid
based on the Dispense/Meter Rate setting and the displacement of the Motor/Base module. To stop metering
operation remove the rear panel trigger signal, or push the Stop push-button.
When drawback is used, the Drawback, Drawback Rate, and the Drawback Dwell (time between the forward and
drawback portions of the cycle) settings are shown on the Drawback screen.
3.5
INSTALLATION
General operating practices provide the best guidelines for locating the components of the system. The Controller
Module should be located for ease of use during all phases of operation and maintenance.
3.6
MAINTENANCE
No periodic maintenance is required on the Controller Module, beyond standard practices for electronic equipment.
3.6.1 Assembly/Disassembly Procedures
The Controller Module contains the following replaceable parts.
•
Main Power Fuse
3.6.1.1 Main Power Fuses
The main power fuses are located in the Power Entry Module on the rear panel is replaceable. The proper fuse value
is described in the Title Page section of this manual.
Disassembly
1. Remove the power cord.
2. Using a small flat blade screwdriver, open the power entry module's cover.
3. Slide the fuse tray out and remove the fuse.
Assembly
1. Install the new fuses into the fuse tray and slide the tray in.
2. Close the power entry module's cover.
3. Connect the power cord.
3.7
PROBLEM GUIDE
Table 3.9 contains a list of possible problems, causes and solutions for the Controller Module.
WARNING
Hazardous voltages exist inside the Controller Module. Under no circumstances should the Controller
Module be opened. There are no user serviceable parts inside the Controller Module. Any unauthorized
access to the inside will void the warranty.