Iveco Stralis MY 2016, Body Builder Instructions

Page: 24 / 254

18
NEW STRALIS MY2016
‒
GUIDELINES FOR BODYBUILDERS
GENERAL INFORMATION
1.16
INSTRUCTIONS FOR PROPER FUNCTIONING OF THE VEHICLE PARTS AND ACCESSIBILITY
–
Printed 692.68.697
–
5 Ed. - Base 03/2019
Exhaust system accessibility (only diesel versions)
Each outfitting must ensure access to the exhaust gas post-treatment assembly (muffler) and, in particular, to the cover of the
ceramic particulate filter housing.
245554
Figure 8
Above and around the muffler, the outfitting must be kept at a minimum distance of 80 mm to allow any vertical and transversal
movements which may be required when removing the silencer.
Remember that the weight of the assembly is approximately 120 kg and that the temperature on the surface can reach 250
°
C in
certain conditions.
Distance from muffler
▶
Assemblies or parts made using flammable material must never be fitted near the vehicle's ex-
haust system.
Take into consideration that:
●
synthetic materials must never be exposed to temperatures exceeding 70
°
C; adequate protections must be implemented if
higher temperatures are expected (thermal shielding).
The factory mounted fuel tank is made from materials belonging to this class and therefore, if fitting in a position that is not
original, particular attention must be exercised.
●
the minimum distance between the muffler and the cab rear wall, gearbox and braking system components must be at least
50 mm.
●
the minimum distance between the exhaust pipe and brake pipes, wiring, spare wheel must be at least 200 mm; this value may
drop to 80 mm if using protections.