Iveco Stralis MY 2016, Body Builder Instructions

Page: 14 / 254

8
NEW STRALIS MY2016
‒
GUIDELINES FOR BODYBUILDERS
GENERAL INFORMATION
1.9 QUALITY SYSTEM MANAGEMENT
–
Printed 692.68.697
–
5 Ed. - Base 03/2019
1.9 QUALITY SYSTEM MANAGEMENT
IVECO has always promoted the training and development of a Quality System for Bodybuilders.
This requirement is not only due to regulations on product liability, but also to the increasingly higher quality level demands, new
organizational forms in various sectors and the search for more advanced levels of efficiency.
IVECO therefore considers it appropriate for Bodybuilders to be equipped with:
●
organizational charts for roles and responsibilities;
●
quality objectives and indicators;
●
design technical documentation;
●
process documentation, including controls;
●
plan for product improvement, also obtained through corrective actions;
●
post-sales assistance;
●
training and qualification of staff.
The availability of ISO 9001 certification, even though not required, is considered very important by IVECO.
1.10 ACCIDENT PREVENTION
Do not allow unauthorised personnel to intervene or operate on the vehicle.
It is forbidden to use the vehicle with safety devices that have been tampered with or are damaged.
▶
Structures and devices installed on the vehicles must comply with the applicable regulations for
accident prevention, and with safety regulations required in the individual countries where the
vehicles are used.
All precautions dictated by technical knowledge must be taken to avoid damage and functional defects.
Compliance with these requirements must be overseen by the manufacturer of the structures and devices.
▶
Seats, coatings, gaskets, protective panels, etc., may pose a fire hazard when exposed to an in-
tense heat source. Remove them before working with welding and with flames.
1.11 CHOICE OF MATERIALS TO USE: ECOLOGY - RECYCLING
In the study and design phase, the choice of materials to be used by be made carefully, even from the ecological and recycling point
of view.
To this regard, please note that:
●
it is forbidden to use materials that are harmful to health, or at least which may pose a risk, such as those containing asbestos,
lead, halogen additives, fluorocarbons, cadmium, mercury, hexavalent chromium, etc.;
●
it is advisable to use materials whose processing produces limited waste quantities and allows easy recycling after first use;
●
in synthetic materials of the composite type, it is advisable to use components that are compatible with each other, allowing
use with the possible addition of other recovery components. Prepare the required markings in accordance with the regula-
tions in force;
●
the batteries contain substances that are very dangerous for the environment. To replace the batteries it is possible to go to
the Service Network, equipped for disposal in accordance with the nature and the law.
▶
To comply with Directive 2000/53 EC (ELVs), IVECO prohibits the in-vehicle installation of com-
ponents that contain lead, mercury, cadmium and hexavalent chromium; exceptions are made
in cases allowed by Annex II of the above Directive.