Iveco NEW DAILY, Instructions Manual

Page: 64 / 240

40
NEW DAILY
–
CHASSIS INTERVENTIONS
CHASSIS INTERVENTIONS
2.13
WORK ON SHEET METAL
–
Printed 603.95.789
–
1 Ed. - Base 02/2014
Work on the roof
a) Fitting a transparent roof
At the time of publication of these Directives, it is still not possible to collect information and components for this kind of conver-
sion.
b) Fitting an hatch
It is possible to fit an hatch on the roof provided that this task does not affect the ribbing and that the seal and strength of the mod-
ified parts are not affected.
Figure 24 shows an installation example.
208216
Figure 24
1. Cutting area 2. Anchorage profile
3. Sealant
c) Modifying the height of the roof
Three roof versions are available in production having respective inside heights of:
●
low roof = 1595 mm
●
medium roof = 1900 mm
●
high roof = 2100 mm
Modifying the height of the roof is a very demanding and difficult task: this task should therefore only be performed on medium
and high roofs, since they have the same roof structure.
Figure 25 shows the cross-section of the two versions, highlighting that the roof is a standardised structure.
To allow correct connection with the original roof, the Body builder must envisage appropriate intervention on the side ribbing.