Iveco NEW DAILY, Instructions Manual

Page: 129 / 240

NEW DAILY
–
POWER TAKE-OFFS
POWER TAKE-OFFS
4.5 PTO MANAGEMENT
9
–
Printed 603.95.789
–
1 Ed. - Base 02/2014
●
the power take-off must be located immediately downstream of the gearbox; for vehicles with the drive line in two or more
sections, the power take-off may also be fitted at the flexible support between the first and second sections (respect the in-
dications given in Chapter 2.8 (
➠
Page 26));
●
the angles of the drive line on the horizontal plane and vertical plane must be kept as close as possible to the original values;
●
masses and rigidity added to the drive line must not provoke a loss of balance or abnormal vibrations or damage the transmis-
sion drive line (from engine to axle) either during vehicle movement or during operation with the power take-off;
●
the power take-off must be fixed to the chassis with its own suspension.
▶
The transmission is an important part for the safety of the vehicle, and as such any intervention
on the transmission must only be carried out by specialist companies approved by the manufac-
turer.
Note Any intervention on the driveshaft carried out without prior authorisation from IVECO will immediately invalidate the warranty.
4.5 PTO MANAGEMENT
Note At the time of publication of these Directives, the information in this Chapter may have been subject to changes. It is therefore
recommended that any possible modifications are verified by consulting www.ibb.iveco.com .
General information
For first equipment the vehicle can be alternatively equipped with:
a) PTO pre-installation
(Opt. 77910 on gearbox 2840.6 and 2850.6 and Opt. 75977 for gearbox 2835.6);
PTO pre-installation consists of:
●
cover on gearbox (see Figure 3);
●
bonnet cable (see Figure 5).
Refer to the following paragraph for PTO installation (point 1)
Note There is always a cover on the gearbox on gearboxes 2840.6 and 2850.6 (see Figure 3), while the cover is only present with option
75977 on gearbox 2835.6).
b) PTO pre-installation (Opt. 77910 on gearbox 2840.6 and 2850.6 and Opt. 75977 for gearbox 2835.6) and Expansion
Module (opt. 8657)
PTO pre-installation consists of:
●
cover on gearbox (see Figure 3);
●
bonnet cable (see Figure 5).
The Expansion Module is an electronic interface designed to manage certain types of configurations (additional lights, alarms, "after
market" PTOs, etc.) and is pre-installed on the vehicle.
Refer to the following paragraph for PTO installation (point 2)
Note There is always a cover on the gearbox on gearboxes 2840.6 and 2850.6 (see Figure 3), while the cover is only present with option
75977 on gearbox 2835.6).
c) PTO (Opt. 75076/75077/75078) and Expansion Module (opt. 8657)