15
The fi rst time the controller is turned on and after the
language and time are set, a query appears as to wh-
ether you want to parametrise the controller using the
commissioning help or not. The commissioning help
can also be terminated or called up again at any time
in the special functions menu. The commissioning
help guides you through the necessary basic settings
in the correct order, and provides brief descriptions
of each parameter in the display. Pressing the “esc”
key takes you back to the previous value so you can
If you decide not to use the commissioning help, you should make the
necessary settings in the following sequence:
- Menu 6.
Special functions - clock, Additional functions
- Menu 4.
Settings, complete
Finally, menu 3.2 under operating mode “Manual“ should be used to test the
switch outputs with the consumers connected, and to check the sensor values for plausibility.
Then switch on automatic mode.
look at the selected setting again or adjust it if desired. Pressing the “esc“ more than once
takes you back step by step to the selection mode, thus cancelling the commissioning help.
Finally, menu 3.2 under operating mode “Manual” should be used to test the switch outputs
with the consumers connected, and to check the sensor values for plausibility. Then switch
on automatic mode.
Caution
Observe the explanations for the the individual parameters on the following
pages, and check whether further settings are necessary for your application.
Parametrisation
F.1. - Commissioning help
F.2. - Free commissioning
Caution
Observe the explanations for the the individual parameters on the
following pages, and check whether further settings are necessary
for your application.
