7
C O B R A
5 1 0 0 5 9 9 R e v . D
Hook Installation:
A mounting hook is included for hanging the COBRA gun against a wood or sheet
metal surface when not in use. Locate the hook at the desired mounting level and
mark hole locations. Drill 1/8” pilot holes and secure the hook with the screws
and spacers provided. Note that spacers should be placed between the hook and
the mounting surface before installing screws.
5. OPERATION
Before energizing any power supply:
1. Ensure that all power supplies are properly grounded.
2. Ensure that all static control devices are properly grounded.
3. Ensure that all static control devices have been properly located, positioned
and installed.
After the above checks have been performed, simply energize each power supply
to operate the static control device.
For optimal performance,
fi
rst blow off the target surface with the gun held as
close to the surface as required to remove dirt and dusts. Then, use a broad sweep-
ing motion with the gun 12” to 24” from the surface. Be sure that the ionized air
stream from the gun contacts all areas of the target surface to ensure thorough
static neutralization.
The COBRA gun is supplied with an accessory nozzle that produces a fan-shaped
ionized air blast. The accessory nozzle may be used to increase the area covered
for cleaning purposes.
Switch the power supply unit off during prolonged periods of non-use such as
plant shutdowns and overnight. This will ensure a long ionizer life with optimum
ion output.
CAUTION –
Personal Protective Devices Recommended – Always wear
safety glasses or goggles when operating blow-off gun. The purchaser is
responsible for providing effective chip guarding to protect personnel in
the area from blown debris. Also, wear hearing protection if the blow-off
gun is operated more than 1½ hours per day.
