ITV ICE MAKERS - IQN NUGGETS, User Manual

Page: 11 / 12

ENGLISH
11
6.3 REMOVING RESIDUES PROCEDURE
1. In order to make sure that there is no residues that could have remained in the machine, rinse the water reservoir cover (A) and the
ice outlet Cover (C) with water and place these items in its respective position.
2. Also, rinse the Ice Fallen Tube (E) with the brush and the inside of the ice storage bin.
3. Place the back panel and the top panel to its original position.
4. Then, allow the machine operate for 30 minutes in the freeze cycle and melt or discard all the ice that will be made.
6.4 CLEANING STORAGE SENSOR
This must be done every time the machine is cleaned. Also in case the machine stops without the storage being full.
It is accessed through the top of the machine. Remove the sensor from its support by removing the fixing screw.
With a soft paper and alcohol clean the area of dark glass. NEVER USE ORGANIC SOLVENTS WHICH COULD DAMAGE THE
PLASTIC SURFACE.
Reassemble and check operation: LED off indicates free sensor. Blue LED on indicates sensor activated (presence of ice).