ITRON OpenWay OWR-1000-001, Installation Manual

Page: 18 / 22

Chapter 2 Installation
Mount the Range Extender
Note Perform each procedure in the order listed in the Installation Checklist on
page 5.
To permanently mount the range extender, perform the following procedure.
To mount the range extender
1. If the permanent mounting location is significantly different from the location first
attempted, you may need to perform the procedures
Link to a CENTRON Meter on
page 8 and Link to the Gas Module on page 10 again to verify that the radio links are
satisfactory for the exact location where the device is going to be mounted
permanently.
2. Position the range extender in the optimum location determined by the procedures
Link to a CENTRON Meter on page 8 and Link to the Gas Module on page 10.
3. Using two screws, mount the device to a stationary object.
Caution Do not over-tighten the screws as this may damage the range extender's
polycarbonate case.
4. Record the range extender location, according to your company asset management
requirements.
Note Any additional magnet activations or configuration changes performed on
either the gas module or the range extender after the range extender is permanently
mounted require you to perform all of the steps in
Link to a CENTRON Meter on
page 8 and Link to the 2.4GZ OpenWay Gas Module on page 10. Performing these
procedures reestablishes the radio paths between all the devices.
12 DRAFT OpenWay Installation Guide