Installation
10
CENTRON® Polyphase Meter Technical Reference Guide
7
Replace the board-to-board connector by aligning the top of the connector with the
notches in the circuit board and pressing gently at the bottom of connector to mate the
connector to metrology board. Then, gently press the top of the connector to mate it to
the register module. The connector is seated correctly when you hear it snap into place.
Figure 5: Circuit Board Notches
Be sure to use the meter base for leverage instead of the LCD
holder. Pressure on the LCD holder may damage the
personality module.
Figure 6: Board-to-Board Connector, Bottom
