17
Display Function
© 2018 ITEL SNC
2.2.2
Pre Enphasis, Audio Level and Clipper
In the second submenu of the Mpx Encoder you can adjust the audio signal input level at 0.5dB steps,
activate the clipper and pre-phase. If a fine adjustment of the input level is required, it is possible to act
on the TRIM trimmers placed next to the audio input connectors that allow a continuous adjustment of +/-
0.5dB.
2.2.3
Pilot Level And Phase
In the third submenu of the Mpx Encoder you can set the level and phase of the pilot tone of the stereo
coder.
2.3
Rds Encoder
The second available menu is Rds Encoder, the parameters in this menu are related to the
programming of the internal coder.
2.3.1
PS,PI, PTY Indications
In the first submenu of the Rds Encoder the following parameters are shown:
PS:
Program Station Name
PI:
Program Identification,
TY:
Program TYpe,
MS:
Music/Speech, 1 for the most of the time music programs, 0 for the most of the time speech programs.
TP:
(Traffic Program) 1 indicates that the issuer, during programming, provides traffic information, but
these are not necessarily aired at the moment.
TA:
(Traffic Announce) 1 indicates that, at present, the issuer is providing a traffic information program
The PS will only be shown when the coder generates RDS signal internally. In the 'override AF tables' mode,
the PS already on the MPX input will be aired.
In this case, the word 'OVERRIDE' will be indicated instead of the PS.
Summary of Contents for STL-SAT Changeover
