Quick
Start
Copyright ©ITECH Electronic Co., Ltd.
8
keys
Name and functions
enable marking at bottom of each key.
Dot
.
Esc key, to exit at any working status
.
To select constant current mode and set current input value
.
To select constant voltage mode and set voltage input value
.
To select CR-LED function.
To select constant power mode and set constant power input value
.
Confirm current setting or operations.
To control input status of load: on/off
.
Up key, to select menu items during menu operation
.
Down key, to select menu items during menu operation
.
Left/Right key, to adjust the cursor to the specified location to set
the value
.
2.4
Fast function key
A combination of front board keys and Shift composition keys in IT8912E can
realize functions marked at key bottom. For details, see table below.
keys
Name and functions
+
(Short)
To start or end short circuit test.
+
(Tran)
To set dynamic operation parameters.
+
(List)
To set list operation function.
+
(Save)
To save existing setting load parameter values, e.g.,
voltage, current and power.
+
(Battery)
To operate battery test function.
+
(Prog)
To operate auto test function.
+
(Info)
To display model, version number and serial
number of electronic load.
+
(System)
To set system menu.
+
(Config)
To configure system menu.
+
(Pause)
To pause operation during automatic test.
+
(Trigger)
Trigger key, to start up triggering functions.
+
(OCP)
To operate OCP test function.
+
(Setup)
To set specific parameters of constant voltage,
constant current, constant resistance and constant
power.
+
(OPP)
To operate OPP test function.
+
(CR)
To select constant resistance mode and set
resistance input value
.
+
(Recall)
To select stored load parameter values, e.g.,
voltage, current and power setting values.
ESC
