3030 Corporate Grove Dr • Hudsonville • MI • 49426
Phone: 616-396-1355 • www.itc-us.com • [email protected] • DOC#: 710-00016 Rev G • 12/17/18
Bluetooth Single Zone Control Install Instructions
(Part #’s: 230-00041)
Safety Instructions
• Disconnect power before installing, adding or changing any component.
• To avoid a hazard to children, account for all parts and destroy all packing materials.
• Do not install any luminaire assembly closer than 6” from any combustible materials.
• Positive (+) inputs require a fuse if the attached wire leads are not rated to handle the max current.
1.
INSTALL:
Determine the installation location for your controller. Make sure to consider the size of the controller when determining your
location. Note, it will require room for access and for wiring. Once determined the single zone controller can be attached with double
stick tape.
• First clean the back of the module and the install location with alcohol wipes (not provided). Place the double stick pads
(not provided)on the back of the module as shown below. Remove the paper and stick the module in place.
• Do not install in an area where the controller will get wet.
PARTS / TOOLS NEEDED:
RGBW Bluetooth Controller
RGB or RGBW Lighting
(Varies)
Double Stick Tape -
Optional (not provided)
Alcohol Wipes
(not provided)
Ø2.8”
Double
Stick Tape
2.
WIRING DIAGRAM:
Follow the wiring diagram below to wire the module to your system.
Outputs
Controller
Black - 12-24V DC IN (-)
Red - 12-24V DC IN (+)
(Max 192W)
Inputs
(+) Black
Red
Green
Blue
White
Zone 1
4A Max per RGBW Wire
(See recommended color above)
0.9”
Tape on bottom
of controller
3.
WIRING CONSIDERATIONS:
- Don’t power the controller or lights until all connections are made.
- It is recommended that strain relief be added on all wires to prevent any damage to the lights.
- If fuses are not included on the RGBW controller then ITC recommends including fuses on each zone output (+) wire.
- If installing a flexible lighting product, do not install the end caps in the mounting track or it may damage the light.
- To test the lights, select the single color fade for each of the colors, red, green and blue on the HaoDeng app. This test will show
whether there are wiring issues.
For warranty information please visit www.itc-us.com
