Itasca latitude 37G, Manual

Page: 65 / 135

6-5
SECTION 6 –
ELECTRICAL
ELECTRICAL GENERATOR
–If Equipped
Automatic Power Transfer Switch
Whenever the generator is needed, an
automatic power transfer system automatically
switches the household electrical system to the
generator 10 seconds after the generator is
started. The ten-second delay allows the
generator to start easily without the burden of
electrical loads.
Generator Basic Operation
To Start the Generator
Press and Hold the Generator switch in
START position until you hear the generator
running smoothly, then release.
To Stop the Generator
Press and Hold the Generator switch in STOP
position until you hear the generator come to a
full stop, then release.
See the generator manufacturer’s information
provided in your InfoCase for detailed operating
instructions, troubleshooting and maintenance.
Generator Hourmeter
This meter is located on the monitor panel. It
registers the total number of hours that the
generator has been operated.
Refer to the hourmeter to determine when
periodic maintenance is due and to record
services which have been performed.
Operation Warnings and Cautions
WARNING
Careless handling of the generator and
electrical components can be fatal.
Never touch electrical leads or appliances
when your hands are wet, or when
standing in water or on wet ground.
Do not attempt to repair the generator
yourself. Service should be performed by
an authorized service center.
Do not plug the power cord into the
generator receptacle while the generator
is running.
Automatic Power Transfer box in electrical
utility compartment ( typical installation–
appearance may differ on your model )
WARNING
The exhaust of all internal combustion
engines contains carbon monoxide (CO).
This poisonous gas is colorless, odorless,
tasteless, and lighter than air. The
exhaust systems of both your motor home
engine and your generator engine have
been installed with your safety in mind.
However, certain precautions must be
taken when using them to protect yourself
from conditions beyond the control of the
manufacturer.
Generator Switch and Hourmeter
on monitor panel