Itasca latitude 37G, Manual

Page: 29 / 135

3-5
SECTION 3 –
DRIVING YOUR MOTOR HOME
The rearview camera monitor system lets you
see what’s directly behind your coach for
maneuvering assistance and safety.
A microphone built into the rear camera lets
you hear warning sounds or verbal directions
from an assistant.
Basic Operating Instructions
*Sideview Cameras
– If Equipped.
The optional sideview cameras allow you to
see what’s beside you before turning or changing
lanes.
The sideview cameras activate with the
corresponding turn signals and replace the rear
camera view on the monitor until the turn is
completed or the signal lever is canceled
manually.
Further Information
See the rearview monitor manufacturer’s
complete operating information in your
InfoCase.
PARKING BRAKE – AUTO-
APPLY/ PULL-BUTTON
–Workhorse UFO Chassis
This chassis is equipped with parking brakes
that apply automatically when the transmission is
shifted into Park.
A brake-transmission shift interlock system
prevents shifting the transmission out of Park
into any other gear until you press the regular
service brake pedal. See your chassis manual for
more information
Auto-Apply
• After you bring the vehicle to a stop, press and
hold the service brake pedal, then press PARK
(P) on the transmission selector.
• Wait five or six seconds for the park brake to
fully apply, then release the brake pedal. You
do not need to pull the park brake knob for the
auto-apply feature.
• The ‘AUTO PARK’ indicator will appear on
the instrument panel when the Park Brake has
applied.
NOTE:If the engine is off, but the ignition is On
and the auto-apply park brake is NOT
applied, the vehicle may roll
unexpectedly. If this happens, the
transmission monitor will display “N”
and a buzzer will sound until you shift to
“P” to engage the park brake system.
• The auto-apply park brake will release
automatically when you apply the regular
brakes and shift the transmission from Park
into any other gear.
Manual Apply (Pull-Button)
The manual apply parking brake knob is
located on the dash near the steering column.
Pull this knob to apply the park brake when
the coach is in neutral or any gear other than park.
It is not recommended to apply the park brake
while at road speed except in an emergency
situation.
See your chassis manual for more information
on pull-button park brake operation.
Power - Turn ON to activate
monitor for rear viewing while
driving or parked. Key must be on.
In OFF (Standby) position the
monitor is ‘asleep’ and will ‘wake
up’ when the transmission is
shifted into Reverse.
Camera -
CA1= Rear or Side* cameras
CA2= not used
Day/Night - Press to adjust
contrast and brightness for
nighttime and daytime lighting
conditions. After making
adjustments, button is used to
switch between settings.
Volume, contrast and brightness
are self-explanatory.