5
Figure 5
3.3.
Preparing the object for installation of the product
Prepare the object for the fitting and welding works in accordance with the requirements of the manufacturer
and other regulatory safety documents related to this type of work.
Make holes on the object in accordance with Fig.6. Holes must be oriented with regard to the subsequent
placement of the connecting cable.
Figure 6
The mounting gasket allows to overlap a hole with a diameter of not more than 44 mm; it must be borne in
mind, however, that the execution of an opening with a diameter larger than indicated in Fig. 6 impairs the quality
of sealing of the product-object interface and reduces the rigidity of the object structure at the place where the
product is installed.
Making a central hole of large diameter makes sense in the case when the product is installed on an object
with a non-planar surface of the object-product interface. The minimum permissible radius of curvature of the
mating surface of the object is 500 mm (arrow 1 mm).
Summary of Contents for GS.01.00.00.000 IM
Page 3: ...3 Figure 1 Figure 2...