Accessories
The following accessories are available to connect the IOM6 CAN/LIN Accessory to the target
CAN, CAN-FD or LIN interface(s).
Ordering Code
Description
IC57040-CAN-DB9
1m CAN cable DB9
IC57040-CAN-JACK
CAN cable banana jacks
IC57040-CAN-PIN
CAN cable pin wires
IC57040-CAN-T
CAN BUS T adapter
IC57040-LIN-JACK
LIN cable banana jacks
IC57040-LIN-PIN
LIN cable pin wires
BB-FNET-100
1 m FNet Cable (for use with AOM accessories)
BB-FNET-300
3 m FNet Cable (for use with AOM accessories)
BB-FNET-500
5 m FNet Cable (for use with AOM accessories)
The topology of a CAN network is shown in the
network require termination using a 120 Ohm impedance, connected between the CAN_H and
CAN_L signals.
iSYSTEM accessories provide the termination impedance via a switch on the DB9 connector. In
the default switch position the termination impedance is not connected.
If the IOM6 CAN/LIN is connected at one of the ends of the network (node A or D in the
diagram above) the 120 Ohm termination impedance can be enabled using the switch on the
iSYSTEM connector accessories. If connected to the CAN bus at the position of nodes B and C,
no termination is required.
Find more information on
. To reach
for technical support please visit
.
