9
How to Install the ISONAS PureIP Reader-controller
1.4
: INSTALLER TOOLKIT COMPONENTS
Before an installer goes to a customer site, they need to put together their supplies and tool-kit.
The ISONAS solution is simpler to install than other Access Control Systems, but to be successful,
other materials are still needed. And some of these items may be different than what you are use
to carrying. The list below identifies some important items that you should make sure to bring with
you, to the customer’s site.
A prepared installer will have:
Completed the on-line reseller training program.
Determined the reader’s required network configuration, based on the
customer’s networking topology.
Pre-configured the reader’s network configuration.
An installer’s Tool Kit should include the following:
1.
A copy of the Pure IP Reader-Controller Installation and Wiring Guide
2.
A Volt-Ohm Meter
3.
Pin-in-Torx Screwdriver
o
T-8 (Tamper Resistant)
4.
1 1/8 inch hole-saw (If mounting is done without a J-box)
5.
A PoE Injector
6.
A Cross-over Cat5/6 cable
7.
A straight-thru Cat5/6 patch cable.
8.
Basic Ethernet network cable tester (Tests for: Opens, Shorts, Split Pairs,
Mis-wires & Reversals)
9.
A spare Pure IP Reader-Controller
10.
An extra Pure IP Reader-Controller Pigtail
11.
Silicon Caulking for sealing the Pure IP Reader-Controller to exterior walls
12.Dielectric Silicon Grease (Dow DC-4) for protecting cable connections.
13.
The ISONAS Pure IP Reader-Controller As-Built forms, which is used to
record the details of the door's installation.
14.
Credentials that match the customer system’s technology
o
ISONAS Proximity
o
HID Proximity
o
DESFire EV2 Smart Cards
