7
Product Version 1.0 | Revision A | Released 2022-2-21
BEFORE INSTALLING THIS PRODUCT
Please visit the SGM official website at sgmlight.com for the latest version of this user manual /
safety information leaflet. Due to continuous improvements, the instructions may change with
-
out notice. SGM always recommends the latest available firmware version from sgmlight.com.
EXTERNAL CLEANING AND VISUAL INSPECTION OF THE FIXTURE:
All users of SGM fixtures should regularly clean those parts of the fixture directly exposed to the
elements, such as the external housing and front lenses. Additionally, all owners of SGM fixtures
must periodically check the external housing of the fixture for structural breaks, components in
bad shape, cracked lenses, or loose screws. To ensure proper operation, but also to prevent the
risk of potential accidents, do not use the fixture if the lens, housing, or power cables are dam
-
aged. If parts of the fixture appear to be missing, cease use immediately and contact SGM sup
-
port.
WIRING AND CONDUIT / CONTAINMENT:
SGM fixtures supplied with power and data cable leads are not intended for installation in per
-
manently installed conduit or containment. When installing fixtures in a permanent installa
-
tion, ensure cable leads are installed as a service loop to an appropriately rated junction box
using suitable cable strain reliefs / glands. All installed fixtures must be securely mounted and
service loop appropriately protected for installation location. All electrical wiring and connec
-
tions should be completed by a qualified electrician.
SAFETY PRECAUTIONS
When using electrical equipment, basic safety precautions should always be followed including
the following:
•
1. Do not mount near gas or electric heaters.
•
2. Permanently installed equipment should be mounted in locations and at heights
where it will not readily be subjected to tampering by unauthorized personnel.
•
3. The use of accessory equipment not recommended by the manufacturer may cause
an unsafe condition.
•
4. Do not use this equipment for other than intended use.
•
5. Refer service to qualified personnel or authorized service centers.
•
6. Do not look directly into the beam for long periods of time, when the fixture is on.
•
7. The fixture shall, under no circumstance, be covered with insulating material of any
kind.
READ AND FOLLOW ALL SAFETY INSTRUCTIONS