Linear units with toothed belt drive: LEZ 1/LEZ 2/LEZ 3/LEZ 9
Assembly instructions
Page 44
11
Declaration of incorporation in accordance with MD 2006/42/EG
Declaration of incorporation in accordance with EC Machine Directive (MD) 2006/42/EG, Ap-
pendix II B
The manufacturer
isel Germany AG
Bürgermeister-Ebert-Straße 40
D-36124 Eichenzell, Germany
hereby declares that the product
(partly completed machine)
Product description:
Linear unit with toothed belt drive LEZ 1/LEZ 2/LEZ 3/LEZ 9
complies with the basic health and safety requirements of EC Machine Directive 2006/42/EG Appendix
I.
The following harmonised standards were applied:
EN ISO 12100-1:2003 Safety of machinery - Basic concepts, general principles for design - Part 1:
Basic terminology, methodology
EN ISO 12100-2:2003 Safety of machinery - Basic concepts, general principles for design - Part 2:
Technical principles
EN 349:2008-09
Safety of machinery - Minimum gaps to avoid crushing of parts of the human
body
EN 14121-1:2007
Safety of machinery
– Risk assessment – Part 1: Principles
EN 60204-1:2006
Safety of machinery - Electrical equipment of machines - Part 1: General re-
quirements
The following additional EC Directives relevant to this product were applied:
Low voltage directive 2006/95/EC
The
technical documentation
for this partly completed machine was produced in accordance with
Appendix VII Part B. The manufacturer undertakes to pass on these technical documents to national
authorities in electronic form on request.
Member of staff responsible for producing the technical documents or assembly instruc-
tions/Declaration of incorporation is:
Mr Helmut Danz
The product (partly completed machine) is intended for installation in a machine or for combining with
other partly completed machines to form a single machine as defined in MRL 2006/42/EC, Article 1,
Section (1) a.
This partly completed machine (product) must not be commissioned until the machine in which
this product is installed or or which it forms a component meets the provisions of all the rele-
vant directives (especially MD 2006/42/EC) and this (complete) machine carries a CE mark.
Place and date:
Dermbach, 18th October 2011
_____________________________
Werner Kister, CEO