IGEP
TM
RADAR SENSOR ORION Hardware Reference Manual
ISEE 2007
S.L. All rights reserved, IGEP™ is a registered trademark from ISEE 2007 S.L. The following is provided for informational purposes only.
DOCUMENT FROM ISEE 2007 S.L. Ref: MAN-PR-RADR0010-RA1-001
20
6
EXPANSION CONNECTORS INTERFACES
IGEP
™
RADAR SENSOR ORION has 4 EXPANSION connectors JC1, JC2, JC3 and JC4, in order to
allow interface with the sensor in
three different ways
:
EXPANSION-I
14pin 2.54” connector
JC1
Basic Interface.
ONLY +5V
DC
OPERATIONAL
EXPANSION-II
28pin 2.54” connector
JC2
IGEP
™
v2 interface
EXPANSION-III 70 pin 0,3mm pitch
KYOCERA connector
JC3-JC4
IGEP
™
COM MODULE interface
Table 18 : IGEP
™
RADAR SENSOR ORION EXPANSION INTERFACES
EXPANSION-I
is the basic interface connector and is delivered with only GND and power supply
pins operational, but the rest of ports can be activated on demand. The next tables will show
you all the ports possibilities for each expansion. JC1 is SAMTEC P/N: SSM-107-L-DV.
EXPANSION-II
is fully compatible with connector J990 of IGEP
™
v2 processor board, with signals
at 1v8 CMOS to support the features provided by the OMAP3xxx CPU.
EXPANSION-III
is fully compatible with connectors J1 and J4 of IGEP
TM
COM MODULE
processor board thanks to JC3 and JC4 corresponding connectors which are 70-pin (AVX 5602
series) with signals at 1v8 CMOS to support the features provided by the OMAP3xxx CPU.
6.1
PINOUT TABLES OF EXPANSION CONNECTORS
Below pin tables show pin out of IGEP
™
RADAR SENSOR ORION expansion connectors (JC1, JC2,
JC3 and JC4).
Each table has several columns:
PIN
: PIN NUMBER OF THE CONNECTOR. SUBINDEX MEANING:
o
PW: Power Line
o
DIG: CMOS DIGITAL SIGNAL PORT 1V8 LOGIC LEVELS
o
DIG3: CMOS DIGITAL SIGNAL PORT 3V3 LOGIC LEVELS
o
DIG5: CMOS DIGITAL SIGNAL PORT 5V LOGIC LEVELS
o
ANA: ANALOG PORT
o
NC: PIN NOT CONNECTED
NAME
: FUNCTION OF THIS PORT. SUPERINDEX MEANING:
o
(L): ACTIVE LOW LEVEL
o
(H): ACTIVE HIGH LEVEL
