IGEP
TM
RADAR SENSOR ORION Hardware Reference Manual
ISEE 2007
S.L. All rights reserved, IGEP™ is a registered trademark from ISEE 2007 S.L. The following is provided for informational purposes only.
DOCUMENT FROM ISEE 2007 S.L. Ref: MAN-PR-RADR0010-RA1-001
11
5.2
SUMMARY
DEVICE
CONNECTOR
REFERENCE COMMENTS
POWER SUPPLY
Power Jack
JP1
+5Vdc Power Supply
USB 2.0 OTG
miniAB USB
Connector
JC5
On-board. OPERATIONAL ONLY with
IGEP
™
COM MODULE
EXPANSION-I
POWER SUPPLY
14pin 2.54”
connector
JC1
Basic Interface. ONLY +5V
DC
OPERATIONAL
EXPANSION-II DDS-
ADC-CONTROL
28pin 2.54” connect
JC2
IGEP
™
v2 interface
EXPANSION-III DDS-
ADC-CONTROL
70 pin 0,3mm pitch
KYOCERA connector
JC3-JC4
IGEP
™
COM MODULE interface
TEST
COAXIAL UFL
connectors
JF1-JD1-
JD2-JL1
TEST AND MONITOR connectors
EEPROM
-
UP5
On-board.
Table 6 : Interface summary
5.3
POWER SUPPLY
JP1 connector is a power jack for main +5V
DC
power supply.
It is P/N RASM722BK SWITCHCRAFT connector, Plug/Mating Diameter 2.1mm ID, 5.5mm OD.
Figure 4: JP1 POWER SUPPLY CONNECTOR
IGEP
™
RADAR SENSOR ORION
can be powered through any of several
connectors, JP1, JC1, JC2 or JC5. You MUST USE ONLY ONE of these connectors
to power the board. If you power the board using 2 or more of them at the
same time the board will be DAMAGED.
MAXIMUM POWER SUPPLY VOLTAGE:
+5,2V
DC
PERMANENT DAMAGE WILL OCCUR if higher
voltage is applied.
