SERVICE MANUAL
© ISA, s.r.o. 2014-2015. All rights reserved.
We reserve the right to change the specification without prior notification.
Always check for new version of this document@
Service manual V1.08 | Nov-2015 | LM0002-EN
Page 70 of 97
When integration to home network is required and our network cable
is not available (not present on LVLØ installation place), we
recommend to use power-line adapters. Power-line adapters are
devices that turn a home's electrical wiring into network cables. They
come in handy when you need to bring the Internet connection to a far
corner of the building. A power-line connection is generally also more
reliable than a wireless connection.
4.1.2
WLAN interface
LVLØ controller has built-in wireless access point feature to easily access device after hardware installation
and quickly start with software commissioning. Powered by the technology from the leading chipmaker
Broadcom, the access point delivers a fast and stable wireless network around the
controller.
Standards
IEEE 802.11g, IEEE 802.11b;
Frequency
2.4GHZ
Antenna
1* 5dBi detachable omni-directional antenna (rSMA)
SSID - service set identifier - is a case sensitive, alphanumeric character unique
identifier attached to the wireless local-area network (WLAN) communication that
acts as a password when a mobile device tries to connect - a component of the
IEEE 802.11 WLAN architecture.
NOTE:
All LVLØ controller comes from factory set with same SSID: LVL0 (Lima Victor Lima Zero)
Unique WiFi password (key) is printed on sticker located on left side of LVLØ Controller.
If you have forgotten your WiFi name and password, check on the sticker.
Password cannot be changed.
4.1.3
Remote access
Setting up Port Forwarding on your router allows mobile devices outside the network to access services
provided by LVLØ controller on your network.
4.1.3.1
Setup port forwarding on your home router:
To access Port 80 is used for HTTP and is needed to access the controller from internet.
TCP port 80 > >>> LVLØ IP ADDRESS
After configuring port forwarding, setup Dynamic DNS if needed (section 4.1.3.2) and continue with
connection to LVLØ application (section 5.2.3).