iES26G Series User’s Manual
iS5 Communications Inc.
68
no accounting
I
Clear interface accounting information
switch(config)#interface
fastEthernet 2
switch(config-if)#no
accounting
5.4
Commands Set List—Trunk command set
Commands
Level
Description
Example
aggregator priority
[1to65535]
G
Set port group system
priority
switch(config)#aggregator
priority 22
aggregator activityport
[Port Numbers]
G
Set activity port
switch(config)#aggregator
activityport 2
aggregator group
[GroupID] [Port-list]
lacp
workp
[Workport]
G
Assign a trunk group with LACP
active. [GroupID] :1to3
[Port-list]:Member port list, This
parameter could be a port range
(ex.1-4) or a port list separate by a
comma(ex.2, 3, 6) [Workport]: The
amount of work ports, this value
could not be less than zero or be
large than the amount of member
ports.
switch(config)#aggregator
group 1 1-4 lacp workp 2 or
switch(config)#aggregator
group 2 1,4,3 lacp workp 3
aggregator group
[GroupID] [Port-list]
nolacp
G
Assign a static trunk group.
[GroupID] :1to3
[Port-list]:Member port list, This
parameter could be a port range(ex.1-
4) or a port list separate by a
comma(ex.2, 3, 6)
switch(config)#aggregator
group 12-4 nolacp or
switch(config)#aggreator
group 13,1,2 nolacp
show aggregator
P
Show the information of trunk group
switch#show aggregator
no aggregator lacp
[GroupID]
G
Disable the LACP function of trunk
group
switch(config)#no
aggreator lacp 1
no aggregator group
[GroupID]
G
Remove a trunk group
switch(config)#no
aggreator group 2
