40
C
HAPTER
13
W
EB
I
NTERFACE
: IP A
DDRESS
AND
D
EFAULT
R
OUTES
IP Route Configuration
7.
You will need two routes: one route to your network and a default route to your control center.
Once these routes are established, a remote user can configure the switch for proper configuration.
a.
You will need to configure
VLAN
1 to use the default gateway. This route may already be in
your list. The destination network should be the network for the
IP
Address configured in
section 0, the subnet mask, the interface should be “vlan1”, the switch option should be
“default”, and the distance should be “0”. Click
Add.
b.
Configure the default gateway. The destination network should be 0.0.0.0, the subnet mask
should be 0.0.0.0, and the gateway should be the gateway router IP address. Consult with
your administrator if you do not know this value. Leave the interface blank. The switch should
be “default” and the distance should be “1”. Click
Add.
c.
Click
Apply
S
TEP
R
ESULT
:
You should see a screen similar to the following:
R
ESULT
:
The
IP
address and default routes have been configured on MicroRAPTOR.
