IS5 COMMUNICATIONS IES12G, User Manual

Page: 130 / 177

iES12G User’s Manual
UM-iES12G-1.72.2-EN.docx Pages 119 of 166
© 2020 IS5 COMMUNICATIONS INC. ALL RIGHTS RESERVED
Label Description
Dead Time
The Dead Time, which can be set to a number between 0 and 3600 seconds, is the
period during which the switch will not send new requests to a server that has failed
to respond to a previous request. This will stop the switch from continually trying to
contact a server that it has already determined as dead.
Setting the Deadtime to a value greater than 0 (zero) will enable this feature, but only
if more than one server has been configured.
4.1.12.4.1.2 RADIUS Authentication Server Configuration
The table has one row for each RADIUS Authentication Server and a number of columns, which are:
Figure 117 - RADIUS Authentication Server Configuration
Label Description
# The RADIUS Authentication Server number for which the configuration below applies.
Enabled Enable the RADIUS Authentication Server by checking this box
IP Address
The IP address of the RADIUS Authentication Server. IP address is expressed in dotted
decimal notation .
Port
The UDP port to be used on the RADIUS Authentication Server. If the port is set to 0 (zero),
the default port (1812) is used on the RADIUS Authentication Server.
Secret
The secret - up to 29 characters long - shared between the RADIUS Authentication Server
and the switch.
4.1.12.4.1.3 RADIUS Accounting Server Configuration
The table has one row for each RADIUS Accounting Server and a number of columns, which are:
Figure 118 - RADIUS Accounting Server Configuration
Label Description
# The RADIUS Accounting Server number for which the configuration below applies.
Enabled Enable the RADIUS Accounting Server by checking this box
IP Address
The IP address of the RADIUS Authentication Server. IP address is expressed in dotted
decimal notation .