GSM модем iRZ TC65 Lite
User Manual
13
2.5. Menu Mode
The menu mode is designed to change the modem parameters and view the statistics. In this
mode the GSM module power supply is disconnected, after the exit it is started automatically. You
can jump to the menu mode from the operation mode by extracting the SIM tray. Before jumping
into the menu mode, connect the modem to the computer through the connector DB9, start Hyper
Terminal (time rate is 115200 bpc, 8-N-1) or a similar program.
If you have entered the menu mode successfully, the LED indicator will flash frequently (see
Table 2.6.1), the main menu will be displayed in Hyper Terminal:
Menu_mode:
Variant XX
<P1> View statistics
<P2> WD interval = XXX hh
(or “OFF”)
<P3> 'AT' control = ХХХ min
(or “OFF”)
<P4> Sleep mode
(Power Standby)
= OFF
(or “ON”)
<PC> Power control
<PR> Clear statistic
,
where
Variant XX
is the weaving version.
The characters <…> signify the control commands. Input of the command gets underway after
clicking “Enter”. In case of incorrect input, “ERROR” is indicated. There is no difference between
the entered uppercase and lowercase characters.
After input of the command “
P1
” you jump to the statistics viewing menu:
Power_Modem = XX…X
Bad_Power_Modem = XX…X
Power_Module = XX…X
Bad_Power_Module = XX…X
Start_Module = XX…X
Bad_Start_Module = XX…X
ComPort_is_not_Running = XX…X
Deadlock_of_module = XX…X
Reset = XX…X
When the modem is used, the following situations are automatically saved:
Power_Modem –
number of modem connexions,
Bad_Power_Modem
– number of power supply deviations of the modem from the allowed
value,
Power_Module
– number of power supply feedings to the GSM module,
Bad_Power_Module
- number of power supply deviations of the GSM module from the allowed
value,
Start_Module
– number of successful GSM module starts,
Bad_Start_Module
– number of situations where the GSM module did not start,
ComPort_is_not_Running
– number of situations: COM is not available (CTS signal),
Deadlock_of_module
– number of the GSM module deadlocks,
Reset
– number of restartings.
After the statistics output, you will jump to the main menu.
After input of the command “
P2
” you will jump to the WD menu:
