Irrigatia Ltd, Norwoods, Long Drax, Selby, YO88NH, UK
01904 202243,
www.irrigatia.com
User Instructions for Irrigatia IRR-SOL-C120
Positioning
Mount the controller close to the water source and
low down so that the pump inlet is below the water
line in the tank (Fig 1). The controller case is weather
resistant but can be mounted inside if desired. The
solar panel should be mounted, facing the midday sun
within 5m of the controller’s location
. The panel can
be plugged in to the socket on the base of the
controller. The screw collar on the cable is for use
where an extension cable is required if the panel must
be more than 5m away.
Water inlet strainer and level sensor
Insert the inlet tube with the water strainer on the end so that the
tube is vertical in the tank and the strainer is resting on the bottom
(fig 2). The water level sensors should be attached to this so that one
is 2 -3 cm above the inlet hole, one hanging well below it (fig 3).
During operation, if one of the sensors is out of the water the pump will stop
and the beeper will sound. If the beeper is a nuisance it can be silenced by
unplugging it from the circuit board.
Water outlet tube & filter
to protect the drippers from sediment, there is a fine
mesh filter. This can be fitted on either side of the
pump, (fig 1) but a valve must be fitted between it and
the tank to turn off the water flow while cleaning.
(Valve 3 in fig 1)
Figure 3
Figure 2
Figure 1
Figure 4
