Copyright 2020 Iron Bow Technologies
21
CLINiC Administration
You can modify the default functions of the CLINiC codec by logging in as an
administrator to the codec web interface and performing the desired changes.
For the complete set of instructions, please refer to the
Cisco Webex Codec plus
Administrator Guide:
Accessing the Codec Web Interface
To access the web interface:
1.
In your web browser address line, enter the system IP address, for example,
To display the system IP address, press and hold the Hang Up button on
the CLINiC control panel for 5 seconds or more, and then release. This
will display the system information on the CLINiC screen, including the
system IP address.
2.
Enter the Admin ID as the user name (default is:
admin
), and enter the Admin
Remote Access Password, if one is set.
3.
The Admin screen can now be used to navigate through the menus to the required
location to change a setting, as outlined in the following pages.
4.
It is important that after any changes to the configuration are made these are
saved using the
SAVE
button in the top right hand corner
