Putting on the iReliev
®
Conductive Back Wrap
1) Before putting on the Conductive Back Wrap, remove any residue on skin, cream or
ointment. Make sure that your skin is clean. Do not place the wrap on injured or inflamed
areas of the skin, such as wounds, sores, rashes or reddening.
2) Before use, apply iReliev
®
Conductive Gel. Or you may dampen the integrated silicone
electrodes with water but use extreme caution to not oversaturate.
3) Position the Conductive Back Wrap so that the electrode pads are on the area of the
body to be treated. If your lower back aches at waist level, position the wrap so that the
middle of the wrap sits approximately 1 to 2 inches below the waist. The wrap should fit
very snugly around your body as follows:
8
