ircon Modline 5, Operating Instructions Manual

Page: 119 / 156

RS-485 Digital Communications
Modline 5
Rev. L6 Feb 2017
117
6.10 Command Code Summary
Code Command
Description
Type Group Notes
AA Analog alarm output R/W Analog
Out
Sets the Analog Output to a specified value when unit is in any of
two alarm conditions. (Error Codes X107, X109).
AC Auto cal time period
(in hours) R/W Eng. Sets the number of hours between Automatic Checks or performs
immediate check.
AF Analog full scale R/W Analog
Out Analog Full Scale command specifies the measured temperature
that will produce the Analog Output full scale current.
AH Analog output high
temperature alarm R/W Analog
Out Sets alarm condition at the Analog Output if the measured
temperature is above the value for Analog Full Scale Output.
AL Analog output low
temperature alarm R/W Analog
Out Sets alarm condition at the Analog Output if the measured
temperature is below the value for Analog Zero Scale Output.
AO Analog output mode R/W Analog
Out
Sets the Analog Output Current loop range to either 0 to 4 mA or 4-
20 mA.
AT Attenuation
Alarm threshold R/W Eng. Set the percentage value for the attenuation alarm threshold.
AZ analog zero scale R/W Analog
Out Sets the measured temperature that produces the Analog Output
Zero Scale current.
BT Report Isoblock
temperature R/O Eng. Returns the infrared detector isoblock environment temperature in
°C.
CL Set to 1 or 2 color
mode R/W Head Selects One Color or Two Color operation for a Series 5r ratio
Sensor.
DR Peak picker decay rate R/W Head Sets the peak picker decay rate in F or C. Zero (0) sets the unit to
never decay.
DT dirty window threshold R/W Eng. Dirty Window Detector Sensitivity Warning Setting
EM Emissivity R/W Head Sets Emissivity for single color or ratio units in one color mode
ES E slope R/W Head Sets the E-Slope for Ratio Sensors in the 2 color ratio mode
FT Features Matrix R/O Eng. Returns bit values for the features the Sensor supports.
KL Keyboard lock R/W Eng Locks or unlocks the Sensor’s rear panel keyboard.
LS Laser Control R/W Eng Turns the sighting laser on or off.
MD Model R/O Eng Returns the Model number of the Sensor.
MT Match Temp Display R/W Head Writes temperature value to be displayed to match target.
Read replies Emissivity or E-Slope value
PD Peak delay R/W Head Sets the delay time before Peak Picker action starts.
PK peak picker reset
below
R/W Head Sets the temperature at which Peak Picker action starts with Auto
Peak Picker Reset Function
PR Peak and reset write Head Write Only Command, Resets the Peak Picker
PS Peak picker auto reset R/W Head Selects Peak Picker Auto Reset operation
RC Case temperature R/O Eng Returns Sensor’s internal Case temperature.
RP Relay polarity R/W Eng Sets the polarity of the alarm relay.
RR Alarm Operation R/W Eng When this is turned on, it also enables the attenuation alarm.
RT Response time R/W Head Sets the Sensor Response Time.
SG Signal Conditioning R/W Head Turns Peak Picker or Track and Hold on or off.
SN Serial Number R/O Eng. Returns the serial number string of the unit.
ST System alarm status R/O Alarm Sensor returns bit mapped values for alarms and the current
measurement condition status.