iQMS362i CE
Operator’s Manual
888-274-7744
www.iqpowertools.com
En
gli
sh
BE SURE TO FOLLOW SAFETY RULES AND INSTRUCTIONS.
MANY COMMON PROBLEMS CAN BE SOLVED EASILY BY UTILIZING THE CHART BELOW.
FOR MORE SERIOUS OR PERSISTENT PROBLEMS, CONTACT IQ POWER TOOLS AT 1-(888)274-7744.
TROUBLE! SAW WILL NOT START
WHAT’S WRONG?
WHAT TO DO
1. Saw not plugged in
1. Plug in saw
2. Cord is damaged
2. Have cord replaced by authorized service center
3. Brushes worn out 3. Replace brushes
4. Upper guard is not well locked
4. Have the upper guard locked.
5. PRCD should be reset every time plug is disconnected 5. Reset the PRCD
TROUBLE! SAW MAKES UNSATISFACTORY CUTS
WHAT’S WRONG?
WHAT TO DO
1. Dull blade
1. Replace blade
2. Blade not cutting
2. Use dressing stone
3. Build up on blade
3. Use dressing stone to remove build up
4. Incorrect cutting blade for work being done
4. Change the blade
TROUBLE! CUTTING WHEEL DOES NOT COME UP TO SPEED
WHAT’S WRONG?
WHAT TO DO
1. Extension cord too small of a wire gauge or too long 1. Replace with adequate size cord
2. Low house voltage 2. Contact your electric company
TROUBLE! MACHINE VIBRATES EXCESSIVELY
WHAT’S WRONG?
WHAT TO DO
1. Stand or bench on uneven floor
1. Reposition on flat level surface
2. Damaged saw blade
2. Replace blade
TROUBLE! DOES NOT MAKE ACCURATE CUTS
WHAT’S WRONG?
WHAT TO DO
1. Cutting guide not secure to fence 1. Check and adjust
2. Cutting wheel is not square to fence 2. Check and adjust
3. Cutting wheel is not perpendicular to table surface 3. Check and adjust
4. Work piece moving
4. Use edge guide
TROUBLE! LOSS OF VACUUM SUCTION
WHAT’S WRONG?
WHAT TO DO
1. Vacuum motor not running
1. Check vacuum and motor plug
2. Filter plugged
2. Spin filter cleaning knob
TROUBLESHOOTING GUIDE
15.1
