iPOWER TPD-800A User Manual
6
example:
A1 Err
）
, and the buzzer alarms at the same time.
5. Individual current, total current, voltage, temperature & humidity over the Limit monitoring
5.1 When individual load current, total load current, voltage, temperature & humidity value are lower than the
Min., the TPD-800A screen displays as
A.1
(that means the load current of outlet No. 1 is lower than the Min.
value)
5.2 When individual load current, total load current, voltage, temperature & humidity value are higher than the
Max., the TPD-800A screen displays as
A.1..
(that means the load current of outlet No.1 is higher than the Max.
value)
6. Self-checking Parameter Monitoring
Make the OUTLET N0.1 display
- - - - - -
, then press reset button, the TPD-800A LED screen sequentially
display the TPD-800A self-checking parameter for one minute.
7. Stopping alarming
Click the RESET button to stop alarming for one minute (When TPD-800A has alarm information, OUTLET
No.1 has no function, you have to stop the alarming for one minute then you can check other information. But it
will continue alarming after one minute until you have modified the fault.)
8. Master / Slave TPD-800A Configuration
Press the RESET button for 12 seconds(the interval of RUN light is 2 seconds), the indicator of M/S on indicates
the TPD-800A is the master TPD-800A; Press the RESET button for 6 seconds(the interval of RUN light is 2
seconds), the indicator of M/S off indicates the TPD-800A is the slave TPD-800A. Account the time please refer
to the RUN indicator (T= 2S)
9. Daisy-chain Connection Method
9.1 Each TPD-800A owns the sole default address which is different from others. The address has been locked
before leaving factory and can not be changed.
9.2 Set one TPD-800A as master and the others as slaves. One master can daisy-chain 9pcs TPD-800A slave at
most.
9.3 One end of the network wire connects to the LINK port of the master TPD-800A, the other end connects to
